• Hardware initiated Secure-Erase feature offers two fast erasure levels: destructive or non-destructive
• Write-Protect feature is a function of the hardware and is enabled via an external signal or switch
• Provision for on-board BIOS for system boot directly from storage media
• Support for multiple storage vendors enables ideal selection for environmental performance
• Convection or conduction cooled; uses industrial temperature range components (-40°C to +85°C operating); conformal coating required for extended temperature operation
• Complete solution includes storage, PMC and software. Each assembled unit is configured and undergoes functional testing to confirm reliable operation of the entire unit before shipment

• Means of securing media from unauthorized write or erasure of data where it’s most needed
• Hardware initiated write protection and secure erasure helps prevent unintended intervention, since no OS is required for implementation
• Cost effective mass storage, eliminating cables and the need to use SCSI based storage solutions for applications requiring moderate storage capacities
• Solves rugged embedded mass storage requirements

Compatibility
Compliant with PCI Local Bus (v. 2.3), the Secure PMCStor supports 3.3 VIO signaling and mounts to boards that provide PMC sites designed to IEEE P1386.1. The disk controller is ATA-2 compliant. The Secure PMCStor is RoHS compliant. The assembly is available with conformal coating, applied in accordance with MIL-I-46508, Type UR. Designed for operation on conduction cooled single board computer platforms per the VITA 20 specification. Heat conduction areas are provided at the center and front of the board, as well as at the upper and lower edge of the board. The Secure PMCStor may be used on any board supporting standard PMC sites such as CompactPCI and VMEbus Single Board Computers, as well as expansion adapters.

Software compatibility: VxWorks and Linux; Windows has limited support - please ask about that and other operating systems.

CompactFlash I and II Note
The CompactFlash II minimally exceeds the component height limit in the IEEE 1386.1 specification by 1.3 mm including retaining bracket. This is not typically an issue for the vast majority of boards.

Interface
Typically, no cabling is required to use the Secure PMCStor since the drive is on-board. The data security feature can be initiated via a toggle switch for Write-Protect, a push-button for Secure-Erase, or via the Pn4 rear-I/O connector. Write- Protect can also be enabled via an on-board DIP switch

CompactFlash Card Capacities
Capacities and manufacturer specifications are continually changing and improving. Please consult factory for the most current information.
Industrial CompactFlash
Capacity-
Type I : 1, 2, 4, 8 GB
Type II: 8, 16 GB

IDE/ATA Controller Specifications
• ATA-2 Channel implemented via on-board FPGA
• Independent DMA channel with 8K FIFO
• Supports single- and multi-word DMA transfers
• MDMA Mode 0, 1, 2 and PIO modes 0,1,2,3, and 4
• 32-bit 33MHz PCI interface
• Compatible with Microsoft IDE/ATA drivers
• Compliant with PCI 2.3
• 3.3 VIO signaling (not 5V tolerant)
• 2 CF slots support type I and II, 3.3V powered
• Front panel CF slot capable of hot swap
• Hardware initiated Secure-Erase (for supported Compact- Flash card vendors only)
• Hardware enforced Write-Protect